Manufacturers' Specifications
Metra KS76 Accelerometer

Output	ICP compatible
Piezo Design	Shear
Voltage Sensitivity	5 mV/ms^-2 ± 2% ≈ 50 mV/g - see calibration certificate
Frequency Response	0.3 Hz .. 10 kHz - see calibration certificate
Residual Noise [20 .. 50 kHz]	0.8 mms^-2 ≈ 80 µg
Linear Range	± 1200 ms^-2
Maximum operational shock (Peak)	5000 g
Constant Current Supply	2 to 20 mA
Output Bias Voltage	8 to 12 V
Resonant Frequency	> 34 kHz
Transverse Sensitivity	< 5 %
Operating Temperature Range	-20 to 120 °C
Temperature Coefficient	-0.16 %/K
Temperature Transient Sensitivity	0.08 ms^-2/K
Magnetic Field Sensitivity	12 ms^-2/T
Weight without cable	23 grams
Case Material	Stainless Steel
Cable Connection	Axial
Cable Connector Thread	10-32 UNF
Mounting Thread	in base - M5
Recommended cable	Low noise accelerometer type

Accessories : all in a plastic case with foam cut outs
001 Probe : attach the accelerometer via the M5 thread, press onto the test object perpendicularly - for estimating and trending measurements above 5 Hz and below 1000 Hz.
002 Adhesive Wax : For quick mounting of light sensors at room temperature and low acceleration. Roll wax in fingers to soften, smear thinly on test surface and press transducer onto the wax - using the DB 0765 cement stud avoids wax blocking the accelerometer thread.
004 Cable Clamps : If screwed onto the test object together with the accelerometer, it avoids any force introduced via the cable into the transducer.
006 Insulating Flange : with M5 threads and 'spanner'. Avoids earth loop problems, not recommended above 100 °C.
008 Mounting Magnet : with M5 mounting thread, suitable for fixing to a magnetic object with a smooth surface. If not available weld or epoxy a steel mounting pad to the test surface. For the best high frequency result apply a thin layer of silicon grease between the surfaces.
017 Cable Adaptor : BNC / 10-32 UNF
050 Cable : with 10-32 UNF plugs - 1.5 m long, 80 °C.

DB 0765 Cement Stud : 10-32 UNF thread - 14 mm Ø - on sale or return
QA 0013 Hexagon Key : for tightening 10-32 UNF studs
YQ 2960 Mounting Stud : 10-32 UNF thread, 12 mm long. This is the best fixing method and for the best high frequency performance. Apply a thin layer of silicon grease between the sensor and the test surface. Recommended torque = 1 Nm.

E&OE - specifications subject to change without notice.